Distortion of the depression on the rear of the blank in broaching

Abstract

When using continuous-cast billet in pipe rolling, it is expedient to roll the billet prior to broaching, so as to improve the structure and properties of the steel. To that end, a three-high screw-rolling mill for billet reduction has been installed at the TPA-80 pipe-rolling unit at OAO Sinarskii Trubnyi Zavod. Introduction of the new process was associated with increase in the rejection rate on account of indentations in the pipe. These indentations may be attributed to the depression formed at the rear of the billet in reduction and the subsequent formation of metallic semicircles on broaching; the semicircles break away and enter the deformation zone. The sources of the indentations on the rolled pipe are investigated. The broaching of the billet on a screw rolling mill is mathematically simulated. Recommendations are made with a view to reducing the surface defects on pipe produced by the TPA-80 unit with a reduction mill. © 2013 Allerton Press, Inc.